Skip to content
We Ship World Wide!
Shop Our Categories
Solar Hydronic Heaters
Solar Water Heating Collectors
Off Grid Solar Water Systems
Solar Hot Water Tanks
Solar Expansion Tanks
Solar Controllers & Pumps
Solar Pump Stations
Solar Water Heating Controllers
Solar Misc Parts
Solar Piping & Fittings
Solar energy monitoring
Solar Heat Exchangers
Solar Package Kits
Solar Water Heating Kits
Solar Pool Heating Kits
Commercial Solar Heating Kits
Solar PV Kits - ON Grid
Solar PV Panels
MIsc Solar PV Parts
Closed Loop versus Drain Back
Solar Water Tank Info
Evacuated Tubes vs Flat Plate Collectors
FAQ - Knowledge base
Solar Space Heating
Solar Piping & Fittings
3/4 Inch Insulated Flexible Twin Solar Pipe w/Data Cable, 2x 50ft Roll
Fast and professional solution
Fast & Flexible
List Price: CAN$800.00 Exc GST/HST
508.00 Exc GST/HST
Designed for quick installation of solar hot water system. This flexible stainless steel solar pipe speeds up the solar installation and provides a much more economical way of running the pipes to and from your roof to the mechanical room. This flexible solar pipe is an affordable way of making your solar installation more professional and
The flexible stainless steel pipe comes complete with sensor wire for connecting thermal probe at the collector. Complete with 3/4" EPDM insulating rubber. 2 Lines (supply and return) of 50' include per box 100' total.
Size: 50ft Length ( 2 x 50ft lengths)
Approx Weight: 12Kgs
Nominal dimension 5/8" OD=3/4"
Closed Cell Elastomerer, EPDM
Temperature Range: -50DegC to +150 DegC
Water Vapour Permeability: >3000
Thermal Conductivity: W/(m.K)
0 DegC: 0.034
24 DegC = 0.037
32 DegC = 0.038
40 DegC = 0.039
3/4" UV Resistant Material
Tough external Coating to protect from Birds.
Temperature Sensor Wire
Operating range: -100DegC to +300 DegC
Copper Wire: 0.75mm2
Voltage: 300/500 V
Electrical Resistance: 23 Ohm/km
Stainless Steel Pipe
This is a nominal 5/8" 304 Steel, this is the sort of steel that is used in Cooking pans, sinks, fridges, tabletops etc. This type of steel is one of the most frequently used types of steel. It is used widely in food processing equipment, in particular in the brewing industry for beer and wine. In short it is used a lot and is good for fluid applications.
Time and Cost Savings
This flexible steel pipe is about 50ft long.
It is a twin hose for your supply (50ft) and return line (50ft).
It has the sensor cable built in, pre insulated and coved with a tough plastic coating for exterior exposure
To run a normal copper line will take the following steps
Buy 2 x 50ft rolls of copper (approx cost $110 each) = $220
Buy 50ft Cable = Approx $25
Buy 100 ft (50ft supply and 50ft Return of EPDM Insulation) = Approx $5.5 Per foot = $550
Total so Far = $795
begin the install..... count the hours to do all this.
Run one roll of copper, don't forget it is stiff and takes a good effort to run it where you want!
Be sure not to kink it!
Run the second roll of copper.
Now bring out the solder, flux and blow torch to secure your fittings
Flush system to remove any Flux acid inside
Test for leaks
Attach the EPDM Insulation (it is in 6ft lengths) to each pipe and secure it with tie wraps.
Stop to bandage up all you knuckles up after you scrape your skin trying to wrap the insulation and tie wrap it under the floor or behind drywall.
Run the wire / temperature sensor and secure it to the insulation.
Remember all this pipe and insulation is likely behind dry wall, under floor boards etc - very time consuming!
Cover the outside of the Insulation with UV resistant coating to stop the sun ruining the insulation or the birds pecking at it!
Buy 50ft of our Flexible Solar Pipe
Unwrap the pipe and run it from the mechanical room to the roof.
Install and tighten fittings with wrench
Flexible stainless steel solar pipe OD 3/4" (nominal 5/8")
Dual Coil (supply and return line) included 50 feet each
UV Resistant protective coating
Built in sensor wire for solar collector temperature probe.
3/4" Thick High Temp EPDM Solar Insulation
High R Value - 7.5
Important Note: High Temperature Seals
Please note, we thought about getting the type of connection that does not need a tool to make the flat seal end on the steel tube. The "tool less" type of connection use 2 spanners/wrenches that screw the connection together and compress a
onto the Flexible steel tube.
However these types of connectors use a silicone seal o-ring which can get damaged easily. Also the silicone seals might not be rated to as high a temperature as the the High Temp washers we include, +350 Deg C.
If you don't think you need such a high temperature rating, please note the Evacuated tube collectors we sell have a Stagnation temperature of 270 Deg C. If your electricity goes off in August and the solar pump stops working for an hour or two, the system will stagnate and the Glycol/Water Mixture in the collector header can approach 270 C. The gaskets at the collector need to handle this type of temperature.
Click the extended features tab to see how much time and effort you can save with this flexible pipe.
You may also like...
30 Tube Solar Collector
CAN$1,453.00 Exc GST/HST